Build & Run Your Own Bitcoin Node On A Raspberry Pi

In this video, we're going to build our own Bitcoin Full Node using a Raspberry Pi. By running your own node, you can skip using a third party, and directly make transactions on the Bitcoin network without any additional fees. You'll also be helping to keep the Bitcoin network decentralized.

Visit my blog for the full written guide to building your own node - https://www.the-diy-life.com/build-run-your-own-bitcoin-node-on-a-raspberry-pi/

Get the 3D print and laser cutting files - https://www.etsy.com/listing/1019844618

What You Need To Build Your Bitcoin Node:
Raspberry Pi 4B (8GB used) – https://amzn.to/3sh7zmY
32GB MicroSD Card (16GB Min) – https://amzn.to/3sbcEgR
Low Profile Ice Tower (Black version used) - https://amzn.to/3th9r0x
1TB M.2 NVME SSD – https://amzn.to/3g91RBa
External NVME Case (Not the one I used, but similar) - https://amzn.to/3e1rW2p
1TB External SSD (Alternative to above) – https://amzn.to/3a90Aq7
Raspberry Pi Power Supply – https://amzn.to/2QqbBfx
Ethernet Cable - https://amzn.to/3uN4Gfl
4 x 3mm Yellow LEDs – https://amzn.to/3dhgKQ0
4 x 150ohm Resistors – https://amzn.to/32aBkLA
M3 Screws & Nuts - https://amzn.to/2PRw6Cd

Banggood Alternatives:
4 x 3mm Yellow LEDs - https://www.banggood.com/custlink/GvDYjFd2G5
4 x 150ohm Resistors - https://www.banggood.com/custlink/3vGdOFhqGi
M3 Screws & Nuts - https://www.banggood.com/custlink/D3vylPE2mj

3D Printer Used – Creality Ender 3 V2 - https://amzn.to/3mM0qKA
K40 Laser Cutter/Engraver Used - https://amzn.to/3jD8mKR

The above parts are affiliate links. By purchasing products through the above links, you’ll be supporting this channel, with no additional cost to you.

If you've got any ideas for Raspberry Pi, Arduino, or other Electronics projects or tutorials you'd like to see, let me know in the comments section.